User`s guide

46 Using the Remote Control
Zooming Your Image
Follow these steps to zoom in on a portion of the image:
1. Press the
E-Zoom + button on the remote control.
You see a crosshair indicating the center of the zoom-in area.
2. Use the four “arrow” buttons on the remote control to position
the crosshair in the area you want to enlarge.
3. Continue pressing the
E-Zoom + button to enlarge the selected
area up to 4 times.
4. While the image is enlarged, you can:
■ Use the arrow buttons to pan about.
■ Press the E-Zoom – button to zoom out.
5. When you’re done, press the
ESC button to return to the original
size.
Changing the Image’s Aspect Ratio
If you’re projecting a widescreen format image, you can use the
Aspect button on the remote control to change the aspect ratio.
Press the
Aspect button once to change the aspect ratio to 16:9 for
widescreen format. Press it again to return to 4:3 aspect ratio.
note
You must be projecting
Component signal, CVBS
signal, or Y/C signal images
to change the aspect ratio.
You can also change the
aspect ratio using the
projector’s Signal menu. See
page 56 for details.