User`s guide

68 Fine-tuning the Projector
Setting a Password
1. Press the Freeze button on the remote control for about
7 seconds until you see the Password Protect menu:
2. Select
Password and press Enter. You see the message Change
the password?
3. Select
Yes and press Enter.
4. Enter a 4-digit number using the numeric buttons on the remote
control, as shown.
The password will be displayed as
****. After you enter the last
digit, a confirmation screen appears. Enter the password again.
You see the message
Password accepted.
5. After you finish setting the password, press the
Esc button to
return to the Password Protect menu.
Make a note of the password and keep it in a safe place in case you
forget it.
Turning On the Password and User’s Logo
1. Press the Freeze button on the remote control for about
7 seconds until you see the Password Protect menu.
2. To enable the password, select
Power On Protect and press
Enter. Select ON then press Esc.
3. To enable your screen logo, select
User’s Logo Protect and press
Enter. Select ON and press Enter.
note
If a password has already
been set, you see the
Password Protect Release
screen. See “Starting the
Projector With a Password”
on page 69.
Numeric buttons on
remote control