User`s guide

Maintenance and Transportation 77
A replacement lamp can be purchased from an Epson Authorized
Reseller. To find the reseller nearest you, see page 94. Request one of
the following part numbers:
■ PowerLite 260d: V13H010L41
■ PowerLite 280d: V13H010L42
Follow these steps to replace the lamp:
1. Press the P
Power button twice to turn off the projector. When
you hear the projector beep twice, unplug the power cord.
2. If the projector has been on, allow it to cool down for at least an
hour (or until the lamp is cool).
3. Use the screwdriver included with the replacement lamp to loosen
the screw holding the lamp cover (the lamp cover is located on top
of the projector).
4. Slide the cover out, then lift it off.
5. Use the screwdriver to loosen the two screws holding the lamp in
place. (You can’t remove the screws.)
warning
Let the lamp cool before
replacing it. If the lamp
breaks, handle the shards
carefully to avoid injury.
Don’t remove
these screws