EPSON ® Lens Installation Installing an optional lens in the no-lens model of your PowerLite projector ® CPD-18790
Follow these instructions to install an optional lens in the no-lens model of your projector. Warning: To avoid electric shock, disconnect the power cord before starting. 1. Remove the protective seal from the projector. 2. Turn the projector over and use a screwdriver to remove the lens cover. 3. Remove the four screws from the lens mount inside the projector.
4. Remove the front and rear caps from the new lens. 5. Lower the lens into the projector, making sure the focus and zoom knobs face downward so they fit through the slot in the projector’s case. Caution: Make sure to support the front of the lens and keep it level, or you could damage the guide pins. Also, use care not to touch the front or back of the lens. If you do, clean the lens with a soft, lint-free cloth. Make sure focus and zoom knobs face downward. Guide pin 6.
7. Replace the lens cover and tighten its screw. 8. Turn on the projector and verify that it operates normally. Epson is a registered trademark of Seiko Epson Corporation. PowerLite is a registered trademark of Epson America, Inc. © 2004 Epson America, Inc.
Epson® PowerLite® Lens Cover Notice The lens cover is located in the accessories box that comes with the projector. Before you start using the projector, turn it over and attach the lens cover as shown: Epson is a registered trademark of Seiko Epson Corporation. PowerLite is a registered trademark of Epson America, Inc. © 2004 Epson America, Inc.
