Administrator's Guide

Setting Up the Projector
19
Connecting the Computer and Monitor Cables
1. If you’ll be viewing images on a monitor as well as the projection
screen, connect the monitor cable to the projector’s
Monitor Out
port, as shown.
2. Connect one end of the VGA computer video cable to the
projector’s
Computer 1
(VGA) port, and connect the other end
to your computer’s monitor port.
3. Make sure the
Computer 1
switch is flipped to the right, as
shown. If necessary, use the tip
of a pen or a small screwdriver
to slide it over.
4. Tighten the screws on the
connectors.
note
If you’re connecting to an
older Macintosh, you may
need a Macintosh adapter set.
See page 20.
Monitor Out
port
monitor cable
VGA computer
video cable
Computer 1
VGA port
Monitor Out
Stack Out
Computer 2 /
Component Video
Computer 1
Audio
Mouse/Com
S-Video S-Audio/Audio2 L-Audio-RVideo
Remote
R/Cr/Pr
B/Cb/Pb H/C Sync V SyncG/Y
Computer 1
switch
(slide to
right)