Administrator's Guide

Setting Up the Projector

Connecting to an Older Macintosh

If you’re connecting to a Macintosh and the computer and monitor

cables don’t fit properly, you may need to use a Macintosh adapter set.

You can purchase this set from EPSON; see page 14.

Refer to the drawing below to make the proper connections:

1. To use the desktop adapter, remove its cover as shown and set the

DIP switches according to the resolution you want to use, such as

16-inch mode. See your Macintosh documentation for

instructions.

2. Replace the cover and connect the adapter to one end of the

computer video cable. Then plug the cable (with the adapter) into

the monitor port on your Macintosh.

Macintosh

desktop

adapter

(if needed)

Macintosh monitor

adapter (if needed)

monitor cable

VGA computer

video cable