Administrator's Guide

30
Setting Up the Projector
Connecting Component (BNC) Video
If your video source has component (BNC) connectors, you can use
them to project a higher quality video image. Before starting, make
sure the projector and your video device are turned off.
1. Connect the three ends of a BNC cable into the projector’s
R
,
G
,
and
B
ports. (Don’t connect the cables to the projector’s H/C
Sync or VSync ports.)
2. Connect the red, green, and blue leads at the opposite end of the
cable to the corresponding connectors on your video source.
3. If the image doesn’t display properly, you may need to change the
BNC
option in the projector’s Setting menu to
YCbCr
(see
page 79).
To use the projector’s built-in sound system, connect the RCA audio
cable to the
S-Audio/Audio2
ports of the projector (insert the white
plug into the
L
port and the red plug into the
R
port). Connect the
plugs at the other end of the cable to the audio output ports of the
video source.
BNC cable
Computer 2/
Component Video
connectors