Administrator's Guide

36
Displaying and Adjusting the Image
Displaying an Image
Make sure the projector and other equipment are set up and
connected correctly, as described in Chapter 1. Then turn on the
projector, as described below, followed by any equipment you’ve
connected to it.
Turning On the Projector
Follow these steps to turn on the projector:
1. Plug in the projector, as shown below, and remove the lens cap.
The power light on the projector’s control panel glows orange,
indicating that the projector is receiving power but the lamp is not
turned on.
power cord
note
The projector can receive
data from the network
whenever it’s plugged in.
(The projection lamp doesn’t
have to be on.)
power light