Administrator's Guide

Setting up EasyMP.net

Configuring the Projector to the

Network

Make sure the projector is connected to your local area network

(LAN) and equipped with a memory card, as described in Chapter 1.

Then follow the steps below to configure your projector with the

correct TCP/IP address and other network parameters.

Determining How Your Network is Set Up

The way you configure your projector depends on how your existing

network is set up. Note any required parameters, as described below,

depending on the type of network you have in place.

Simple peer-to-peer network

You have a simple peer-to-peer network if it your equipment is

connected through a hub, as shown below:

Before configuring the projector, note the following information:

■

the first three octets of the IP addresses on the network (the first

three octets are the same for all devices):

■

the subnet mask

Hub

Projector name : EasyMP.net

IP Address : 192. 168. 1. 1

Subnet Mask : 255. 255. 255.0

Default Gateway : x. x. x. x

Computer name : PC5

IP Address : 192. 168. 1.5

Subnet Mask : 255. 255. 255.0

Default Gateway : x. x. x. x

Computer name : PC10

IP Address : 192. 168. 1. 10

Subnet Mask : 255. 255. 255.0

Default Gateway : x. x. x. x

192.1

8.1.10

first three octets

Examp