Administrator's Guide

Maintaining and Transporting the Projector
89
Installing Batteries in the Remote
Control
Follow these steps to install or replace the remote control’s batteries:
1. Press the tab to release the
battery compartment cover.
2. Remove any old batteries.
3. Insert two AA batteries as
shown.
4. Replace the battery
compartment cover.
Before using the remote control,
make sure the switch on its side is in
the
ON
position (see below).
With fresh batteries installed, the
remote control should work at a
distance of about 30 feet from the
projector; as the batteries get old,
the remote control’s range decreases
and you may need to replace the batteries.
caution
When replacing batteries,
take the following
precautions:
■
Don’t mix old and new
batteries.
■
Replace batteries as soon as
they run out. If the
batteries leak, wipe away
battery fluid with a soft
cloth. If fluid gets on your
hands, wash them
immediately.
■
Remove batteries if you
won’t be using the remote
control for a long time.
tab