User`s guide

3. Unpack the option card and adjust any switches or jumpers
on it, if necessary. (Check the option card instructions.)
When you handle the card, be careful not to touch any of its
components or the gold connectors. If you need to set it
down before you install it, place it gently on top of its
original packing material with the component side facing
up. Keep the packing materials in case you remove the card
later.
Note
You may want to record the card’s serial number in the
“Equipment Log” at the end of Chapter 1.
4. Hold the card along the top corners and guide it into the
slot, as shown below. (If you are installing a full-length
card, insert the front edge of the card into the
corresponding guide inside the main system board bay.)
top corners
connector
Installing and Removing Options
6-7