User`s guide

tl Set the SIMM sockets to accept standard or high capacity
SIMMS
Li Write-protect the configuration information in the FLASH
memory
Ll Alter the starting video controller base address.
If you need to change any jumper settings, follow the
instructions in this section. The table below lists the jumper
settings and their functions.
Main system board jumper settings
Jumper Jumper
number Description
setting Function
E0191
FLASH memory
1 to 2* Normal boot
2 to 3
Enables FLASH memory BIOS for
recovery operation
E0290 Video controller
1 to 2* Enables onboard video controller
2 to 3 Disables onboard video
controller so you can install a
video controller on an option
card
E0291 Diskette
write-
protection
1 to 2 Enables write-protection (read-
only mode) for any diskette drive
connected to the built-in
controller
2 to 3* Enables read-write capability
(read/write mode) for any
diskette drive connected to the
built-in controller
E0292 NVRAM 1 to 2* Normal non-volatile RAM
operation
2 to 3
Changes EISA configuration or
SETUP values stored in
non-volatile RAM to their default
values
Installing and Removing Options
6-15