User`s guide

3. Using two screws and a grounding clip, attach a plastic slide
rail to each side of the drive. Position each slide rail so its
narrow end is at the front of the drive with its tab facing
outward, as shown below. Then install a grounding clip
under each of the two screws nearest the front of the drive.
slide rails
ab
grounding clips
4. If you have not already done so, remove the front panel
from the system as described in Chapter 5.
5. If you are reinstalling the first drive, locate the two-wire
power cable (P6) attached to connector P5.
If you are installing a second or third drive, locate either the
small (P13) or large (P4) four-wire power cable connector, as
appropriate for your drive’s power socket.
Pull the appropriate cable forward out of the external bay so
you can attach it to the connector on the back of the drive.
7-4
Installing and Removing Disk Drives