User`s guide

Installing an IDE Drive
If you are installing a half-height IDE hard disk drive, you can
install it in either the top or bottom bay. If you are installing a
full-height IDE drive, you must first remove any half-height
drives from the drive bay assembly so the full-height drive can
use both bays. The figures in this section illustrate a half-height
IDE drive installation.
1. Turn the drive bay assembly over and install the drive so
that the component side is facing up, as shown below.
Make sure the ribbon and power cable sockets are at the
end of assembly with the screw hole.
screw hole
2. Align the two mounting holes in each side of the drive with
the two holes in each side of the drive bay assembly. Then
insert the four screws that came with the drive, as shown
above.
Installing and Removing Disk Drives
7-11