User`s guide

Follow the steps below to install the SCSI drive(s) in your
computer. If your system came with a SCSI hard disk drive
installed, you will not need to install a SCSI adapter or the LED
cable, so begin with step 4. Otherwise, begin with step 1.
1. Follow the instructions in your SCSI adapter documentation
to set any jumpers or switches on the adapter card. Then
see “Installing an Option Card” in Chapter 6 for
instructions on installing the adapter in your computer.
You may want to use option slot 8 so the SCSI device cable
can reach the adapter easily.
2. Connect P3 of the SCSI hard disk drive activity LED cable that
came with your computer to interface J0190, located in the
lower right corner of the main system board, as shown below.
I
J0190
3. Connect P1 on the other end of the LED cable to the
appropriate connector on your SCSI adapter. If you
installed two SCSI adapters, remove the plastic tie joining
P1 and P2; then connect P2 to the other SCSI adapter.
4. Remove the SCSI drive from its protective wrapper and
place it on an anti-static surface.
Installing and Removing Disk Drives
7-19