User`s guide

NOTE

If you removed the last device from your SCSI bus, be

sure to reconnect ribbon cable connector P7 to the SCSI

device that will now be the last device on the SCSI bus.

Disconnect the power cable from the power socket on the

drive.

To remove a SCSI drive from the upper internal drive bay,

first follow the steps on page 7-10 to remove the IDE drive

bay assembly.

To remove a SCSI drive from either an external bay or a lower

internal bay, first notice the tab on the end of each slide rail

attached to the drive. To release the drive, press the tabs in

toward the drive; then carefully pull the drive out of the

bay, as shown below.

tabs

7-26 Installing and Removing Disk Drives