User`s guide

Hard Disk Problems
If you think there is something wrong with your hard disk, see
the suggestions below.
you have problems with a newly-installed drive.
Ll If your dealer installed the drive, consult your dealer about
the problem.
c3 If you installed the hard disk yourself, make sure you
carefully followed all the instructions in Chapter 7. Review
the procedures and check all the cable connections to make
sure you installed it correctly. Also check the jumper
settings on your drive to be sure they are set correctly.
Cl If you are having trouble with a SCSI hard disk, make sure
you have set the appropriate SCSI ID number for the drive
and that you installed the terminators properly on the first
and last SCSI devices. See your SCSI drive documentation
for more information.
CL Verify that your hard disk drive was physically formatted.
This type of format is usually done by the manufacturer.
Ll Verify that you ran the SETUP program or the EISA
Configuration utility to enable the built-in IDE hard disk
controller and have defined your hard disk drive type or
parameters correctly. See Chapters 2 and 3.
Ll If you are sure the hard disk has been installed and
prepared properly but you cannot access the drive, review
the instructions in your operating system manual. Make
sure you performed the necessary steps in the installation
process for your configuration.
Cl If you still cannot identify the problem, consult the dealer
from whom you purchased the drive.
Troubleshooting
A-21