User`s guide

Printer Problems
CI Make sure the printer has power and is properly connected
to the computer. (Also, be sure your printer has paper in it.)
Cl Check the printer manual for the printer’s correct DIP
switch or control panel settings.
CI If you are using more than one parallel port or more than
one serial port, check the primary and secondary port
settings in the SETUP program or the EISA Configuration
utility to make sure they are correct. See Chapters 2 and 3
for instructions.
Option Card Problems
Cl Make sure the option card is properly inserted in its slot.
Check the installation procedure described in Chapter 6
and also see the instructions that came with the card.
Cl Be sure that you ran the SETUP program or the EISA
Configuration utility to update your configuration after
installing the card. See Chapters 2 and 3.
Q Check to see if you set the necessary DIP switches or
jumpers on the option card. Also be sure you performed the
correct setup procedures for the software you are using with
the option card. See your option card manual and check
your EISA Configuration utility information for the card.
Cl Check the computer’s power supply limits in Appendix B
and your option card documentation to be sure you have
not installed a card that exceeds the total amperage
allowable in your system.
Cl If necessary, make sure that you used the proper cable to
connect the device to the option card connector.
Troubleshooting
A-23