User`s guide

Caution
Before you turn on the power to your system, you must be
sure the voltage selector switch is set to the appropriate
setting for the electrical power source in your location or you
will seriously damage your system.
To change the voltage selector switch setting, insert the tip of a
ball-point pen or a similar tool into the dimple on the switch.
Then slide the switch to the right to select 115 VAC or to the left
to select 230 VAC.
Installing Optional Equipment
Before you set up and connect your system components, you
may want to install any optional equipment you plan to use.
Chapters 6 and 7 give complete instructions for installing
options such as disk drives, memory modules, and option cards.
You may want to list the serial numbers and other important
information about the options you install in the “Equipment
Note that the order in which you install option cards depends
on the type of cards you have. If you will be installing only ISA
option cards that did not come with their own configuration
(CFG) files, you should install them before you connect your
peripheral devices. Follow the instructions in your ISA card
manual to set the card’s switches or jumpers for your system.
You should also install any EISA cards you plan to use before
you connect peripheral devices so your EISA Configuration
utility can automatically detect the cards and configure them
correctly.
Setting Up Your System 1-5