User`s guide

System board options (continued)
Hard Drive 1
and
Hard Drive 2
Parallel Port
Serial Port 1
Serial Port 2
COM1
Redirection
Settings
Drive Type nn
Hard Drive n Disabled*
Base Address 378h -
Compatible*
Base Address 378h -
Bi-directional
Base Address 278h -
Compatible
Base Address 278h -
Bidirectional
Disabled
Base address 03F8h*
Base address 02F8h
Base address 03E8h
Disabled
Base address 02F8h *
Base address 03E8h
Base address 02E8h
Disabled
Disabled*
1200 Baud
2400 Baud
9600 Baud
Description
Set to the hard disk drive type
of the specified IDE hard disk
drive or set to user-definable
drive types (2, 3, 48, or 49) and
enter parameters according
to the drive’s documentation;
see “Hard disk drive types”
below (1)
Select one of the Compatible
options to set the port for IBM
AT compatible signals; select
one of the Bi-directional
options to set the port for IBM
PS/2 compatible bidirectional
signals; select Disabled to
prevent the port from reacting
to any signals (no resources
are allocated when Disabled)
Select the address you want
to use for serial port 1; set to
Disabled to prevent the port
from reacting to any signals
(no resources are allocated
when Disabled) (2)
Select the address you want
to use for serial port 2; set to
Disabled to prevent the port
from reacting to any signals
(no resources are allocated
when Disabled) (2)
Set to Disabled to prevent
redirection of the computer’s
input and output to the serial
port assigned to COM1: set to
the speed the computer
should use to copy the
redirected input/output to the
serial port assigned to COM1
3-14 Running the EISA Configuration Utility