User`s guide

Publishing Discs 84
Taking Out Discs
Follow the steps below to take out the published/read discs from the stackers.
c
Caution:
If you select stacker 4 as the output stacker in Standard mode or External Output mode,
❏ Do not yank stacker 4 when pulling it out to remove published discs.
❏ Do not pull out stacker 4 when the stacker 4 LED is flashing fast. Discs may be damaged.
1. Open the disc cover (only for output to stacker 2 or 3), and take out the stacker.
2. Take out the published/read discs from the output stacker.
Note:
❏ Once the output stacker becomes full, the job is paused. The job is resumed automatically if you
take out the published discs from the stacker.
❏ Be sure to let printed discs dry completely before using them or touching the printed surface.
Allow Epson specified discs to dry for at least 1 hour and other types of discs for at least 24
hours.
❏ If the print position is misaligned, adjust it using the printer driver. For details, refer to the printer
driver Help.
❏ If the ink smears, adjust the color saturation. For details, refer to the printer driver Help.
❏ When publishing discs using Batch mode, the number of discs output to stacker 3 is not always
the same as the number of discs loaded into stacker 2. Also, the number of discs does not
always become 50. The same applies to the number of discs output to stacker 2. For Batch
mode, the output stacker switches to stacker 2 when the ejected discs accumulated in stacker
3 reach the height limit. As a result, the number of discs output to the stacker depends on the
thickness of the discs used.
Stacker 2 Stacker 3 Stacker 4