Owner`s manual

Using the PriorityFax
The ready display appears.
Press SPKR or lift the handset. You hear the dial tone.
Dial the number of the receiving fax machine. (Include the area
code if the receiving fax machine is outside of your dialing area.)
When you hear the fax tone, press START promptly. Then hang
up if you are using the handset. Unless you press START
immediately, the line is disconnected and you hear the busy
tone.
Note
If the receiving fax machine is not using Auto Answer, a
voice may answer. If this happens, ask the other party to
start fax reception by pressing START and hanging up.
(Since PriorityFax is not a speaker phone, you must use
the handset to talk to the other party.) Press START and
then hang up when you hear the fax tone.
The fax machine pulls the document through the slot as it sends it;
then it beeps once when transmission is complete. (If the
Transmission Verification feature is turned on, the fax machine
prints a report a few moments later.)
If a fax does not successfully reach its destination, the PriorityFax
displays COMM ERROR, beeps several times, and prints a
communication error report.
2-9