Service manual

EPSON Stylus Photo R280/R285/R290 Revision B
Chapter 3 Troubleshooting 3.3 Troubleshooting by Error Message 40
Table 3-10. Troubleshooting for CD-R Tray Error
Occurrence
Timing
Symptom Failed Part Check Point Remedy Reference
When printing on
CDs/DVDs
The CDR Tray is set to the printer,
but the error occurs.
CDR Tray
1. Has the part of the CDR Tray that contacts with
the CDR Tray Sensor become cracked?
1. Replace the CDR Tray.
-
CDR Tray Sensor
1. Is the CDR Sensor cable not connected to CN4 on
the Main Board?
1. Connect the cable to the connector on
the Main Board.
4.4.18 “CDR
Tray
Sensor”(p.94) /
4.3.1 “Main
Board
Unit”(p.61)
2. Is the CDR Tray Sensor damaged? 2. Replace the CDR Tray Sensor.
The CDR Tray center detection
sequence is interrupted, and the tray
is ejected.
CDR Tray
1. Is there any paper dust or foreign matter on the
white mark on the CDR Tray?
1. Remove any dust or foreign matter from
the tray.
-
CDR Tray
Contact point
White Mark