Service manual

EPSON Stylus Photo R280/R285/R290 Revision B
Chapter 4 Disassembly/Assembly 4.1.5 Work Completion Checklist (Overview) 54
PROTECTION FOR TRANSPORTATION
Before packing the printer to be returned to the user, attach several pieces of strong
tape and vinyl sheet to the specified points to prevent damaging the printer during
transportation.
! Securing the Carriage
(tape: 180mm x 1 pc., fold one end by 5mm)
1. Attach 40mm-length portion of the tape (not folded side) to the left side of the
carriage aligning the tape’s corner with the carriage’s ribs as shown below.
2. Attach the folded side of the tape to the housing with the carriage locked at its
lock position. (First move the carriage to the lock position, then attach the tape
to the housing.)
Figure 4-3. Securing the Carriage
Packing Ink
Cartridge
Are the ink cartridges installed
correctly?
OK / NG
Waste Ink Pads Is the remaining capacity of the waste
ink pads enough?
OK / NG
Carriage position Is the carriage located at the position
where the Printhead is covered with the
cap?
OK / NG
Protection (strong
tape, vinyl sheet)
Have the specified parts been secured
with the strong tapes to prevent
damage during transportation?
See “ Protection for transportation”
(p.54)
OK / NG
Others Attachments,
Accessories
Have all the relevant items been
included in/returned to the package?
OK / NG
Table 4-4. Work Completion Checklist
Classification Item Check Point Status
40mm
Step1
Step2
Folded end