Service manual

EPSON Stylus Photo R280/R285/R290 Revision B
Chapter 4 Disassembly/Assembly 4.2.4 Upper Housing (Removing Exterior Parts/Components) 60
2. Slide the Front Housing in the direction of the arrow and remove the Front
Housing from the Upper Housing.
Figure 4-15. Removing the Front Housing
When installing the Upper Housing, be careful of the following:
! Do not pinch the cables.
! Tighten the screws in the order given in
Fig.4-14 (p.59).
! Match the ribs of the Upper Housing shown in Fig.4-14 (p.59)
with the grooves of the Lower Housing.
! As shown in Fig.4-16, match the A part of the Front Housing
with the screw box of the Lower Housing.
Figure 4-16. Installing Upper Housing
[Rear Side]
Ribs
Front Housing
Grooves
Front Housing
Screw box of
Lower Housing
A part of Front
Housing