Color Inkjet Printer Service Manual

Stylus Photo R300/R310 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 41
2.3.3 Removing Housing, Middle
 External View
Figure 2-6. Removing "Housing, Middle"
 Parts/Units which should be removed before removing "Housing, Middle"
Paper Support Assy./Housing, Upper
 Procedure for Removing
1. Remove the screw which secures "Cover, Core" and then remove "Cover,
Core".
2. Pull out "Panel FFC" from "Ferrite Core".
3. Take off the two-sided tape which secures "Panel FFC" from "Housing,
Middle". Then, release "Panel FFC" from the hooks (x2) of "Housing,
Middle".
4. Remove the screw which secures "Cover, Ink Tube", release the hook and
then remove "Cover, Ink Tube".
5. Remove the screws (x4) which secure "Housing, Middle".
6. Lay down the printer backward, put a flat-blade screwdriver or alike into the
slot located on the bottom surface of "Housing, Lower" and then release the
hooks (x2) which secure "Housing, Middle".
7. Lift "Housing, Middle" upward and remove it.
C.B.P 3x8
(4-6kgf•cm)
Hook
Ferrite Core
Two-sided Tape
Cover, Core
Panel FFC
Hook
C.B.S 3x8 (6-8kgf•cm)
1
2
Housing, Middle
C.B.P 3x8 (4-6kgf•cm)
C.B.P 2.5x8
(3-5kgf•cm)
Cover, Ink Tube
Housing, Lower
Slots and Hook
C A U T I O N
Do not damage the hooks of "Housing, Middle" with the flat-blade
screwdriver or alike.