Service manual

EPSON Stylus Photo R320 Revision B
TROUBLESHOOTING Troubleshooting with LED/LCD Indications and Status Monitor 3 Message 9
1.2 Troubleshooting with LED/LCD Indications and Status Monitor 3 Message
This section describes the LED/LCD indication, the STM3 message and the error condition when the printer detects an error in each operation such as the power on, the paper
loading/feeding and the ink absorption operation.
Table 1-3. LED/LCD Indication and STM3
Printer status
Maintenance
LED indication
LCD indication STM3 message Condition for error detection
Communication Error -- --
This error is detected when the printer cannot
communicate with the PC properly.
Ink Low Condition Blink (Ink icon blinks)
Note :
Printing operation can be performed until it becomes ink
end condition even after the error message is displayed on
STM3. However, the Head Cleaning operation may not be
performed due to the Ink Low condition.
This error is detected when the ink consumption
reaches about 90%.
(Note)
When the Ink Low Condition is detected, the
Maintenance LED will blink. The printer will
continue to keep this LED status even if a new
Ink Cartridge is installed in the Ink Cartridge
replacement position. However, this LED status
will be reset (LED off) when "Carriage Unit"
returns to the home position.