User`s guide

5. The EPSON RC+ 5.0 GUI
124 EPSON RC+ 5.0 (Ver.5.4) User's Guide Rev.4
Setup: Controller: Options
This page is used to configure options in the controller. For instructions, refer to 15.
Installing Controller Options.
Setup: Controller: Simulator
This page is used to configure the Simulator. For virtual controllers, the Enable Simulator
checkbox is grayed out and checked. For real controllers, if the firmware supports
simulation, then you can check the Enable Simulator checkbox.
For more details, see
Virtual Controller Configuration in section 8.3.4.