User`s guide

11. Remote Control
272 EPSON RC+ 5.0 (Ver.5.4) User's Guide Rev.4
For the backup parameters when the parameter name and type are same.
(*7) For the array element, specify an element you acquire as the following:
You need to specify an element when acquiring from the head of the array.
Specify the array element in 2Byte value.
1D array
Parameter name&H2C&H0000
Acquire from the head.
Parameter name, element number.
Acquire from the specified
element number.
2D array
Parameter name
&H2C&H0000&H2C&H0000
Acquire from the head.
Parameter name, element number 1, element
number 2
Acquire from the specified
element number.
3D array
Parameter name
&H2C&H0000&H2C&H0000&H2C&H0000
Acquire from the head.
Parameter name, element number 1, element
number 2, element number 3
Acquire from the specified
element number.
You cannot specify a string for the parameter type.
Available number to acquire is up to 100. If you specify a number over the number of array elements, you
have an error.
(*8) Following functions are supported in the firmware 1.13.*.* or later.
- Acquiring and setting I/O port,
- Acquiring and setting I/O word port,
- Acquiring and setting memory I/O,
- Acquiring and setting memory I/O port,
- Acquiring and setting memory I/O word port,
- Execution and abortion of command
(*9) Specify the command and parameters in the double quotation marks.
Following commands are available while Execute is running.
Commands available while Execute is running
Remote Command
Abort
GetStatus
(*10) “Available any time” applies only when the following conditions are met.
When “Remote RS232” is set as the control device,
or
“Remote RS232” is not set as the control device, but set to be used for monitoring.