User's Manual

Setting and Measuring
Waypoints (Waypoint
Function)
The waypoint function acquires the latitude and
longitude for
Current position, and register to the
device as a point.
You can register waypoints to the device by using the
buttons while measuring. By specifying the registered
point, you can display the directions to the point, the
distance in a straight line, and the difference in
elevation. As you approach the specified point, an alarm
sounds. This is not a navigation function.
The Waypoint function is only available for the SF-710.
♪
Note:
By using the PC application (Run Connect), you can setup
Waypoints from your computer.
When setting up from your computer, you can register
waypoints on the map.
U “Setting the Waypoint Function (SF-710 only)” on
page 99
Operation buttons
Registering waypoints
A
Display the measurement screen.
Press C on the time screen.
GPS positioning starts, and the measurement
screen is displayed once positioning is complete.
U “Specifying a GPS (GPS Positioning)” on
page 29
B
Start measuring.
Press C.
C
Stop measuring when you reach a
point you wish to register as a
Waypoint.
Press C while measuring.
D
To register the Waypoint.
Hold down A.
SF-710/510/310 User Manual
Measure
59