User Manual

Table Of Contents
Set the correct default gateway address. You can check the default gateway address from the Network Status part
on the network connection report.
Related Information
& “Making Advanced Network Settings” on page 43
& “Printing a Network Status Sheet” on page 51
E-12
Solutions:
Check the following.
Other devices on the network are turned on.
e
network addresses (IP address, subnet mask, and default gateway) are correct if you are entering them
manually.
e network addresses for other devices (subnet mask and default gateway) are the same.
e
IP address does not
conict
with other devices.
If still does not connect your printer and network devices
aer
conrming
the above, try the following.
Turn o the wireless router. Wait for about 10 seconds, and then turn it on.
Make network settings again using the installer. You can run it from the following website.
http://epson.sn > Setup
You can register several passwords on a wireless router that uses WEP security type. If several passwords are
registered, check if the rst registered password is set on the printer.
Related Information
&
“Making Advanced Network Settings” on page 43
&
“Connecting to a Computer” on page 28
E-13
Solutions:
Check the following.
Network devices such as a wireless router, hub, and router are turned on.
e TCP/IP Setup for network devices has not been set up manually. (If the printer’s TCP/IP Setup is set
automatically while the TCP/IP Setup for other network devices is performed manually, the printer’s network
may dier from the network for other devices.)
If it still does not work
aer
checking the above, try the following.
Turn o the wireless router. Wait for about 10 seconds, and then turn it on.
Make network settings on the computer that is on the same network as the printer using the installer. You can
run it from the following website.
http://epson.sn > Setup
User's Guide
Network Settings
50