User`s manual

3: 13504SPLT DISPLAY UTILITY

UTILITIES (S19A-B-001-03) EPSON 3-17

3.4 13504SPLT Example

1. Type “13504splt /a” to automatically move the split screen.

2. Press "b" to change the bits-per-pixel from 1 bit-per-pixel to 2 bits-per-pixel.

3. Repeat step 2 for the remaining bits-per-pixel colour depths: 1, 2, 4, 8, 15, and 16.

4. Press <ESC> to exit the program.

3.5 Comments

• The PC must not have more than 12M bytes of system memory when used with the

S5U13504P00C board.

• Follow simultaneous display guidelines for correct simultaneous display operation.

• To determine if the CRT will operate correctly when using a dual panel, refer to the “Maximum

Frame Rates” table in the “S1D13504 Hardware Functional Speciﬁcation,” document number

S19A-A-002-xx.

• When editing in 13504CFG with CRT enabled and panel disabled, select “Single Panel” from the

“Edit Panel Setup” submenu.

• When a CRT is enabled, the CRT settings will override the panel settings. If a panel is also used,

the CRT timing values will have to be changed to more closely match the panel's timing.

• A CRT cannot show 15 or 16 bits-per-pixel.

• Do not attach a panel with a 16-bit interface to the S1D13504 when a CRT is also attached.

3.6 Program Messages

ERROR: Too many devices registered.

There are too many display devices attached to the HAL. The HAL can only manage 10 devices

simultaneously.

ERROR: Could not register S1D13504F00A device.

A 13504 device was not found at the conﬁgured addresses. Check the conﬁguration address using

the 13504CFG conﬁguration program.

ERROR: Did not detect S1D13504.

The HAL was unable to read the revision code register on the S1D13504. Ensure that the S1D13504

hardware is installed and that the hardware platform has been set up correctly.