User`s manual

7: 13504PWR SOFTWARE SUSPEND POWER SEQUENCING UTILITY
UTILITIES (S19A-B-001-03) EPSON 3-27
Examples:
To enable software suspend mode, use the following arguments:
/software /enable
To disable software suspend mode, use the following arguments:
/software /disable
To enable the LCD, use the following arguments:
/lcd /enable
To disable the LCD, use the following arguments:
/lcd /disable
7.4 Comments
• The /i argument is to be used when the registers have not been previously initialized.
• The PC must not have more than 12M bytes of memory when used with the S5U13504P00C board.
• Follow simultaneous display guidelines for correct simultaneous display operation.
• Do not use a dual panel with a CRT. Select “Panel Single” whenever using a CRT, even if a panel
is not attached. Also, the panel section of 13504CFG must be programmed to “Single Panel.”
• When a CRT is enabled, the settings for the CRT will override the panel settings. If a panel is also
used, the CRT timing values will have to be changed to more closely match the panel's timing.
• A CRT cannot show 15 or 16 bits-per-pixel.
• Do not attach a 16-bit panel when using the CRT.
7.5 Program Messages
ERROR: Unknown command line argument.
An invalid command line argument was entered. Enter a valid command line argument.
ERROR: Already selected SOFTWARE.
Command line argument /software was selected more than once. Select /software only once.
ERROR: Already selected HARDWARE.
Command line argument /hardware was selected more than once. Select /hardware only once.
ERROR: Already selected ENABLE.
Command line argument /enable was selected more than once. Select /enable only once.
ERROR: Already selected DISABLE.
Command line argument /disable was selected more than once. Select /disable only once.
ERROR: Select /software or /hardware.
Neither command line argument /software or /hardware was selected. Select /software or /hardware.
ERROR: Select /enable or /disable.
Neither command line argument /enable or /disable was selected. Select /enable or /disable.
ERROR: Too many devices registered.
There are too many display devices attached to the HAL. The HAL can only manage 10 devices
simultaneously.
ERROR: Could not register S1D13504F00A device.
A 13504 device was not found at the configured addresses. Check the configuration address using
the 13504CFG configuration program.
ERROR: Did not detect S1D13504.
The HAL was unable to read the revision code register on the S1D13504. Ensure that the S1D13504
hardware is installed and that the hardware platform has been set up correctly.