Installation guide

RC180 Safety and Installation Rev.19 vii
)
NOTE
Before Reading This Manual
)
NOTE
Do not connect the followings to TP/OP port of RC180. Connecting to the
followings may result in malfunction of the device since the pin assignments
are different.
OPTIONAL DEVICE dummy plug
Operation Pendant OP500
Operator Pendant OP500RC
Jog Pad JP500
Teaching Pendant TP-3**
)
NOTE
For RC180, be sure to install the EPSON RC+5.0 to the development PC first,
then connect the development PC and RC180 with the USB cable.
If RC180 and the development PC are connected without installing the
EPSON RC+5.0 to the development PC, [Add New Hardware Wizard]
appears. If this wizard appears, click the <Cancel> button.
Concerning the security support for the network connection:
The network connecting function (Ethernet) on our products assumes the use
in the local network such as the factory LAN network. Do not connect to the
external network such as Internet.
In addition, please take security measure such as for the virus from the
network connection by installing the antivirus software.
)
NOTE
Security support for the USB memory:
Make sure the USB memory is not infected with virus when connecting to the
Controller.