User's Manual

220
Product Status Messages
You can often diagnose problems with your product by checking the messages on the LCD screen.
LCD screen message Condition/solution
Paper setting in the
printer driver is different
from paper information
registered in the printer.
Change paper setting
from the application or
the driver.
For details, see your
documentation.
To change paper information that was registered using Epson Media
Installer, load the paper and then use the control panel.
You can also use Epson Media Installer to change paper information for
paper that has not been loaded.
Depending on the version of Epson Media Installer you are using, you may
not be able to change the paper information.
The combination of the
IP address and the
subnet mask is invalid.
See your documentation
for more details.
Enter the correct values for the IP address and the default gateway. Check
with your network administrator if you do not know the correct values.
SpectroProofer error NN See the SpectroProofer documentation for details on the displayed error
code.
A printer part needs to
be replaced
Contact Epson Support.
For details, see your
documentation.
(maintenance request
code)
A part used in the printer is nearing the end of its service life. Contact Epson
for support and provide them with the displayed maintenance request code.
The error persists until you replace the requested part. If you continue to use
the printer, a printer error will occur.