User's Manual
Table Of Contents
- Introduction
- Basic Operations
- Loading and Removing the Roll Paper
- Loading and Removing Cut Sheets
- Loading and Removing Poster Board
- Viewing and Changing Media Settings
- Replacing Paper
- Using the Paper Basket (T7270/T5270/T3270)
- Using the Large-Capacity Paper Basket (T7270D/T5270D)
- Using the Auto Take-up Reel Unit (T7270 Only)
- Basic Printing Methods (Windows)
- Basic Printing Methods (OS X)
- Printable area
- Using the Power Off Timer
- Canceling Printing
- Saving to and Reprinting on the Optional Hard Disk Unit
- Copying and Scanning
- Print From Folder
- More Ways to Print
- Enlargements and Horizontal and Vertical Banners
- Printing at Non-Standard Sizes
- Printing CAD Drawings
- Switching Roll Paper Automatically before Printing (T7270D/T5270D Only)
- Borderless Printing
- Correct color and print
- Multi-Page/Poster Printing
- Printing Multiple Documents (the Layout Manager) (Windows Only)
- Color Management Printing
- Tips for Using the Printer Driver (Windows)
- Tips for Using the Printer Driver (OS X)
- Using the Control Panel Menu
- Maintenance
- Problem Solver
- Appendix
- Where To Get Help
- Software License Terms
Epson SureColor T-Series User’s Guide
More Ways to Print
100
About Roll Paper Cutting
When performing borderless printing on roll paper, you can specify whether it is left and right borderless printing
or all edges borderless printing, and how to cut the paper in the printer driver's Roll Paper Option. The cutting
operation for each value is shown in the following chart.
Printer driver
settings
Borderless Single Cut Double Cut
Cutting Operation
Explanation
The default printer driver
setting is Borderless.
O The top area may become
slightly uneven depending
on the image since the
print operation stops while
cutting the top edge of the
roll paper.
O If the cut position is
misaligned slightly, small
parts of the image may be
shown on the top or
bottom of the adjacent
pages. If this occurs,
perform Adjust Cut
Position.
U“The Maintenance
Menu” on page 146
O When you print one page
only or print one page
multiple times, the
operation is the same as
that for Double Cut. When
continuously printing
multiple sheets, the printer
cuts 1 mm inside on the
top edge of the first page
and the bottom edge of
the subsequent pages to
avoid showing margins.
O The top area may become
slightly uneven depending
on the image since the
print operation stops while
cutting the top edge of the
roll paper.
O The printed paper is
approximately 2 mm
shorter than the specified
size since the printer cuts
the paper inside the image
to avoid showing top and
bottom margins.
O After cutting the bottom
edge of the previous page,
the printer feeds the paper,
and then cuts the top edge
of the following page.
Although this produces 60
to 127 mm cut-off pieces,
the cut is more accurate.