User's Manual

Epson SureColor T-Series User Guide
Introduction
21
When the Multifunction Scanner is installed
The following illustration shows the installation space
when the dedicated stand is used to attach the
Multifunction Scanner.
Notes when using the printer
Note the following points when using this printer to
avoid breakdowns, malfunctions, and print quality
decline.
O When using the printer, observe the operating
temperature and humidity range described in the
"Specifications Table".
U“Specifications Table” on page 213
Even when the conditions above are met, you may
not be able to print properly if the environmental
conditions are not suitable for the paper. Be sure to
use the printer in an environment where the
paper's requirements are met. For more details, see
the documentation supplied with the paper.
Also, when operating in dry areas, air conditioned
environment, or under direct sunlight, maintain
the appropriate humidity.
O Do not install the printer next to heat sources or
directly in the path of air from a ventilator or air
conditioner. Failure to observe this precaution
could result in the print head nozzles drying and
clogging.
O The print head may not be capped (i.e., may not
move to the right-hand side) if an error occurs and
the printer is turned off without first resolving the
error. Capping is a function for automatically
covering the print head with a cap (lid) to prevent
the print head from drying out. In this case, turn
on the power and wait a while until capping is
performed automatically.
O When the power is on, do not remove the power
plug or cut the power at the breaker. The print
head may not be capped properly. In this case, turn
on the power and wait a while until capping is
performed automatically.
O Even when the printer is not in use, some ink will
be consumed by head cleaning and other
maintenance operations needed to keep the print
head in good condition.
Notes when not using the
printer
If you are not using it, note the following points when
storing the printer. If it is not stored correctly, you may
not be able to print properly the next time it is used.
O If you do not print for a long time, the print head
nozzles may become clogged. We recommend that
you print once a week to prevent the print head
from clogging.
O The roller may leave an impression on paper that is
left in the printer. This can also cause wavy or
curled paper resulting in paper feeding problems
or the print head could be scratched. Remove any
paper when storing.
O Store the printer after confirming that the print
head has been capped (the print head is positioned
at the far right). If the print head is left uncapped
for a long time, the print quality may decline.
* When the thickness of the document to be loaded is
.01 inch (0.25 mm) or larger, ensure that there is
sufficient space both in front of and behind the printer.
U“When you load a document that is more than
0.25mm thick” on page 76
*1 For T7270D/T5270D
*2 For T7270/T5270/T3270
0.39 in.
(10 mm)
0.39 in.
(10 mm)
3.9 in. (100 mm)
19.7 in. (500 mm) *1
23.6 in. (600 mm) *2