User's Manual
Table Of Contents
- Introduction
- Basic Operations
- Loading and Removing the Roll Paper
- Loading and Removing Cut Sheets
- Loading and Removing Poster Board
- Viewing and Changing Media Settings
- Replacing Paper
- Using the Paper Basket (T7270/T5270/T3270)
- Using the Large-Capacity Paper Basket (T7270D/T5270D)
- Using the Auto Take-up Reel Unit (T7270 Only)
- Basic Printing Methods (Windows)
- Basic Printing Methods (OS X)
- Printable area
- Using the Power Off Timer
- Canceling Printing
- Saving to and Reprinting on the Optional Hard Disk Unit
- Copying and Scanning
- Print From Folder
- More Ways to Print
- Enlargements and Horizontal and Vertical Banners
- Printing at Non-Standard Sizes
- Printing CAD Drawings
- Switching Roll Paper Automatically before Printing (T7270D/T5270D Only)
- Borderless Printing
- Correct color and print
- Multi-Page/Poster Printing
- Printing Multiple Documents (the Layout Manager) (Windows Only)
- Color Management Printing
- Tips for Using the Printer Driver (Windows)
- Tips for Using the Printer Driver (OS X)
- Using the Control Panel Menu
- Maintenance
- Problem Solver
- Appendix
- Where To Get Help
- Software License Terms
Epson SureColor T-Series User’s Guide
More Ways to Print
95
In this example, Plain Paper or Singleweight
Matte Paper is selected depending on the
purpose of its use.
5
Set Print Quality and other necessary settings,
and then print.
If a message The Media Type differs to the
setting on the printer. is appears, click Ignore.
Switching to Roll 1/Roll 2 by
Document Size
For example, when you use the following method
often, if you use the settings described below, the
printer can switch between Roll 1 and Roll 2
automatically in accordance with the document size of
the print job.
Usage example
You want to switch automatically to the roll paper with
the smaller margin automatically when printing
drawings of various sizes including A0, A1, A2, and A3.
In this example, the paper is loaded as follows. The
paper type is the same.
Roll 1: A2 width
Roll 2: A0 width
Settings on Windows
1
Using the control panel of the printer, confirm
Best Fit is set in Setup menu > Printer Setup >
Roll Paper Setup > Roll Switch Condition >
Paper Width.
The default Paper Width setting is Best Fit. If
the setting has not been changed, the setting is
Best Fit.
U“Setup menu” on page 147
2
Open the Printer Settings tab of the printer
driver and confirm that Source is Roll Auto -
XXXXX.
XXXXX indicates the width of the roll paper
currently in use.
If the setting is not Roll Auto - XXXXX, click it
and select Roll Auto - XXXXX.
3
For Paper Size, select the Paper Size set in the
application.
In this example, select A1 594 x 841 mm.