Service manual

ADDENDUM
General Description
Stylus-800/fOOO SERVICE MANUAL
1.1.3.3 Error Conditions
The Stylus-1000 detects various errors and indicates them with the LED indicators and buzzer as shown in
table below.
T
de 1-4 El ror Indication
Buzzer
Recovery
Error
+
PAPER INK OUT
LED
LED
ON
OFF
PAUSE
LED
JJ ■ x 3 times I Set the paper and press the
-
OFF
Paper out
buttons as follows :
1. PAUSE
2. LOAD/EJECT
1
Blink
OFF OFF
~m x 3 times
No beeps
Same as above.
Paper jam
Ink low ● 1
Press PAUSE button and replace
the
ink cartridge to new one.
Then,
press PAUSE button again
to resume r)rintina. ● 2
OFF
OFF
J= x 3 times
Replace the ink cartridge and
-
press PAUSE button.
Install the ink cartridge and press
PAUSE button.
--t-
OFF
ON
OFF
ON
Ink end
No ink
cartridge
Carriage Error
J3a x 5 times
T
OFF
OFF
OFF
OFF
Turn off the printer, and turn it on
-
OFF
OFF
again.
)8 x 3 times Set the release lever to the
Release Lever
*I
Backout/Eject
Error with
Continuous
form ● 1
I position to current paper path.
OFF
~ x 3 times
T
OFF ON
)= x 3 times
Service maintenance required.
(Replace the waste ink absorbing
material and reset the protect
counter.)
BLINKS
Waste ink tank
over-flow
Note)
JI : 0.1 second beep
n:
0.5 second beep
■ :
0.1 second interval
❑ :
0.2
second intewal
● 1 :
This is not treated as an error. (Warning)
‘2 : It is not necessary to immediately replace
error.
the ink cartridge until the printer detect ‘Ink End’
1-6
REV.-A
I