Setup guide

Setup Guide: Configure the Printer
25
Print server name
Type any new name up to 47 characters. The default name
is shown below.
(Printer name) - (last 6 digits of the serial number)
Polling interval
Set the polling time from 5 to 90 seconds.
5. Click
OK
to save your changes. If the message
“Configuration successfully done” appears on your screen,
the update is complete.
6. In the file Server Console’s MONITOR.NLM, select the
Connection Information. Check if the print server name
assigned to the Ethernet card has been logged in to the
Active Connections list. It takes up to five minutes to
complete this.
Using EPSON Net!2 to Configure the Card
in Remote Printer Mode
Follow these steps:
1. From the System Console of the file server where you set
the print queue, load the print server module with the
following command (use the print server name which you
assigned in step 4 under “Using NwAdmin to Set Up Your
Printer,” on page 17):
>Load PSERVER print server name
Caution:
Once you make changes to
the Ethernet card, you must
wait until it registers the
settings before you turn off
the printer.
Note:
If the Status Monitor 2
program is open, or if
background monitoring is
turned on, it may interfere
with EPSON Net!2. Close
Status Monitor 2 if it is
running and turn off
background monitoring,
following step 13 on
page 15.
If you have connected more
than one printer with the
same type of Ethernet card
to the network, you can
distinguish the cards by their
MAC addresses. Press and
hold the card’s status sheet
button for three seconds.
See page 10 for details.