Service manual

Stylus C41/42/43/44 series Revision B
Disassembly and Assembly Disassembly 30
6. Release the FFC form the fixing points of the carriage and disconnect the FFC
from the CSIC board connector on the carriage unit.
Figure 2-30. Disconnecting the FFC
7. Release the two hook, fixing between the Printhead unit and carriage cover, on the
both sides of the carriage unit, then pull the unit forward and remove the cover.
Figure 2-31. Release the two hooks
8. Lift the Printhead unit up and remove it.
T When reassembling the CR motor, it contact the lib of Main
frame after turning clockwise.
Figure 2-29. Reassembling the CR motor
T
Tightening Torque for screw
- C.B.S 3x6 screw : 9+/-1 kgf.cm
lib
FFC
Carriage unit
CSIC board
connector