Service manual

Stylus C41/42/43/44 series Revision B
Adjustment Overview 40
6. When the Head ID is input and writes to the EEPROM, the message is displayed
on the bottom column in the menu.
3.1.6 Bi-D
You perform this adjustment to correct differences in printing positions, which is
caused by incorrect of printing timing in right and left directions during the Bi-
directional printing. Therefore, you are required to perform this adjustment after
performing the following operations.
T Replacing the Print mechanism
T Replacing the main board
T Replacing the CR motor
T Replacing the Printhead
1. Choose the “Bi-D” in the “Adjustment menu” as following figure.
Figure 3-11. Choose the Bi-d adjustment
2. Choose the “Print the Bi-d adjustment pattern” in the “Bi-Directional Adjustment
pattern” and click the “OK” button.