Service manual

Stylus C41/42/43/44 series Revision B
Adjustment Overview 44
3.1.8 First Dot Position
This Adjustment revises gap of left margin ( Print start position) of post card printing
and A4 printing.
Figure 3-18. First Dot Position Adjustment
The figure indicated in the center of Adjustment window is the current figure recorded
in EEPROM.
1. Press [Print] button and print Adjustment Pattern.
Figure 3-19. First Dot Position Pattern
2. Measure the distance (left margin) from the paper left edge of print pattern to vertical
pole of print start position.( Refer to Figure 3-36)
3. Change setting by pressing “
r ” “ s ” button beside or under the predetermined figure.
4. If following indication appears, set printer power OFF/ON in order to record
predetermined limit to printer at first.
5. Press [OK] button after confirming.
6. Repeat above 2 to 5 and adjust so that left margin will be 3+/-1.5mm.
T While warming up (Power LED blinking condition),Program
can not be executed (communication error happens). Execute
program on condition that Printer power LED is turning on.
T Whenever input step 1, it changes by 1/2880dpi (0.009mm).