Continuous Ink Supply System for Epson Stylus C88 Installation Instruction For ST Prefilled Version With Auto Reset Chips This Version of the Continuous Ink Flow System comes with Prefilled Cartridges and Auto Reset Chips. You just need to fill the Reservoir bottles and print! The whole operation is very easy. It’s really an effective tool to save your money.
CIS for EPSON Stylus C88 Instruction Thank you for purchasing ST Continuous Ink Supply System. We appreciate your support and will try our best to make your experience with our products a pleasant one. Printing has been a different experience ever since you installed ST Continuous Ink Supply system on your own printer. Just imagining being able to print without regard to the ink level in those expensive little cartridges. Please take your time installing ST Continuous Ink Supply system.
、Installation Procedures: 1) First step Put the CISS on the left side of the printer. In the meantime place all the tubes at correct position. Pull out the small rubber plug from the air hole as above picture shown. Place 4pcs of air filters into air holes, the thicker side is down into tank.
Circumgyrate screwdreiver Separate the right side of deasilly cartridge-car Take off the cover of cartridge-car 4) Fourth step: Set up the Continuous Ink Supply System Remove original cartridge Insert our no-sponge cartridge Close the cover for cartridge into printer carefully 5) Fiveth step: Fix Support Arm Tear off the sticker Fix the balance arm Fix the arm on the 21cm right far from you printer Tear off the sticker of clamp Tear off the sticker Attached the clamp on your printer and let
6) Sixth step : Install tubeline Insert tubelline through the arm Finished 7) Seventh Step: Adjust the tubeline Adjust the tubeline,remove the Cartridge-car back and forth Too long Make sure tubline will not meet printer when printing twist 8) Eighth step Instert the plug Turn on the power switch check wether all thing is usual Make sure the lengh of tubline is enough to reach the far left and right Perfect
9)Nineth step: Nozzle check Usual Broken line The nozzle check patterns are in broken-line, mostly because of small dusk entered into the nozzle, after repeated cleaning, if there is still a few broken line, pls let the printer don’t work about 1 hour, then print the nozzle check pattern, maybe it works well. 4、Reset Procedure: If the indicator light flashing when printing, it tells that you need to reset the chip to full status.
Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the above picture shown, please use refill kits to fill ink into Reservoir bottles. Carefully pull out the rubber plugs from the refill holes.(there is possibility of ink spattering. Be careful!) Refill ink according to the color in short supply. Then put the rubber back. (Please keep the printer and the reservoir at the same horizontal line during the process of refilling ink.) 6.
Notice: 1. Please don’t take out cartridge at random after installing the CIS system. Keep the reservoir bottles on the same level with the printer. 2. Try to keep at least 1/2 inch of ink in the bottles, as you don’t want to run out of ink and draw air into the cartridge. 3. Don’t place the Reservoir Bottles higher or lower much than the printer. 4. To be used in a dry place between 15 and 35 degree. Avoid exposure to direct sunlight. 5.