Operation Manual

Parallel I/F transfer rate

This setting specifies the I/F (interface) transfer rate for the

parallel interface. For most printing, leave this setting set to

Fast

. If you encounter problems, set it to

Normal

Changing the default settings

To change the printer’s default settings, use the control panel

buttons; the control panel lights show your selections.

1. Make sure the printer is turned off and at least 4 sheets

of A4 (210 mm) size or wider paper are loaded printable

side down in the sheet feeder.

Note:

You can also load paper from the manual feed slot or the tractor

feeder.

2. Hold down the

Media Type

button and turn on the printer to

enter the default-setting mode.

The printer loads a sheet of paper and prints a brief

summary and instructions. It instructs you to select the

language that you want messages printed in (English,

French, German, Italian, Spanish, or Portuguese).

3. Press the

Micro Adjust

button until the following lights

indicate the language of your choice; then press the

Pause

button to make your selection.

Loire-p Ref. Guide

Rev.c

A5 size Chapter 6

02-24-97 DR, pass 0

6-10

The Control Panel