Service manual

EPSON Stylus Color 400 Service Manual

Rev. A

1.2.3 Adjust Lever Settings (PG adjust lever)

The adjust lever located on the right side(blue) under the printer cover needs to be set to the proper

position according to the paper you print. (Refer to the table below). Also, if there is any dirt caused by

friction on the wavy or wrinkled paper, this can be prevented by changing the lever position to rear

position (marked with “+”) in spite of paper types.

Paper Lever position PG adjustment value

Normal paper,

Coated paper

Front 0 mm (1.1mm between head and platen)

Envelopes Rear 0.9 mm (2.0mm between head and platen)

Table 1-3.Adjust Lever Settings

Front (Mark "0")

Rear (Mark "

CR Guide Shaft

Bush

Level adjustment lever

Figure 1-2. Adjust Lever Settings