Service manual

Chapter3 Disassembly and Assembly
Rev. A
3-2
5
3.2.4.9 Removing the PE Paper Detector Assembly
1. Remove the housing.(Refer to 3.2.1)
2. Release two fixed hooks securing the PE detector assembly from the back of frame and remove the
PE detector assembly, sliding it upward. Remove PE board assembly and PE lever if necessary.
During assembly, make sure that the tip(sensor part) of the detector lever is in the hole of paper guide
assembly.
WORK POINT
After releasing two hooks, remove
the PE paper detector assembly,
sliding it upward.
PE Lever
Torsion Spring 0.22
PE Board Assembly
PE Holder
This side should be
installed on the frame.
(From back side of the frame)
Figure 3-23. Removing the PE Paper Detector Assembly