Operation Manual

R4C623Setup Guide
Rev_C
A5 size SETUP.FM
10/18/00 Pass 0
R
Proof Sign-off:
Ichihara, CRE Moriyama_______
N.Nomoto _______
_______
Installing the software
Follow the steps below to install the printer software.
1. Make sure that your printer is off.
2. Turn on your computer and start Windows. If the New Hardware
Found screen or any other Wizard appears, click
Cancel
.
3. Insert the printer software CD that is
shipped with your printer in the CD-
ROM drive. The Installer dialog box
opens. (For floppy disk users, insert
the disk in the disk drive and double-
click the
My Computer
icon, the
floppy disk drive icon, and then
Setup.exe.
)
4. Select
Install Printer Driver/Utility
and
click . Then, click
OK
in the dialog
box that appears to start the printer
software installation
Note:
It is possible to install the Reference Guide on your hard drive from the Installer
dialog box, as shown at the right. To install the guide, select
Online Guide
and then click . Then, click
Install Reference Guide
and follow the on-
screen instructions. When the installation is complete, an
ESC980 Guide
icon appears in the EPSON folder. Double-click the icon to open the guide.
5. Follow the on-screen instructions to turn on your printer.
For Windows 98 users, the printer port
configuration starts automatically.
For printers connected via USB cable,
the USB device driver installation
starts automatically at this point. A
message will appear asking you to
restart your computer. Follow this
instruction.
6. After turning on the printer, the Setup
utility opens automatically. Follow
the on-screen instructions to install the ink cartridges, check the print
head nozzles, and clean the print head. When a message appears
informing you that the setup is complete, click
OK
.
Note:
If the Setup utility does not start, proceed to section to install the ink
cartridge using the printer's control panel.
Printed in Japan.00.xx-xx
Copyright© 2000 by SEIKO EPSON CORPORATION,
Nagano, Japan.