Service manual
Table Of Contents
- EPSON Stylus CX3100/3200
- PRODUCT DESCRIPTION
- Operating Principles
- Troubleshooting
- Disassembly and Assembly
- Adjustment
- 5.1 Overview
- 5.2 Adjustment by Adjustment Program
- 5.2.1 Adjustment Program Installation
- 5.2.2 Adjustment Program Start
- 5.2.3 Destination Setting (EEPROM Initialization)
- 5.2.4 Head ID Input
- 5.2.5 Bi-D Adjustment
- 5.2.6 USB ID Input
- 5.2.7 Top Margin Adjustment
- 5.2.8 First Dot Position Adjustment
- 5.2.9 Head Cleaning
- 5.2.10 Ink Charge
- 5.2.11 Protection Counter
- 5.2.12 EEPROM Data Backup
- 5.2.13 Check Pattern Printing
- 5.2.14 EEPROM Data
- 5.3 Firmware Uploading
- Maintenance
- Appendix
EPSON Stylus CX3100/3200 Revision A
Troubleshooting Troubleshooting at Unit Level 21
3.1.2 Error is detected
Flowchart 3-2.
3.1.3 Trouble related to Print
Flowchart 3-3.
Start
Yes
Check error contents by
LCD (See Table 3-1).
Printer error?
Yes
No
No
No
No
No
Yes
Yes
Yes
End
End
Turn power off, unlock
CR and move CR with
hand.
CR cartridge can
move smoothly?
Refer to Table 3-5
Carriage smoothly
moves?
Ink cartridge out
error is cleared?
Ink cartridge out
error?
Maintenance error
Replace waste ink porous
pad and reset counter.
(Refer to “Disassembly and
Assembly” on page 34 and
“Adjustment” on page 57)
Check whether Head
FFC is connected
properly to head.
Replace Ink cartridge
with a new one by
operation panel.
Check CR motor and if
there is no problem,
replace main board.
Start
Yes
Execute test printing
Printing was
successfully
done?
No
Print quality
is normal?
No
No
No
No
No
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
End End End
Execute print
adjustment (Refer to
“Adjustment” on
page 57)
Execute cleaning
All the cables
are connected
properly to main
board?
Connect correctly
Problem is
solved?
Refer to Table 3-5
Problem is
solved?
Replace main board
Problem is
solved?
Problem is
solved?
Problem is
solved?
Replace Ink cartridge
and execute test print.
Refer to Table 3-5