Service manual

EPSON Stylus Photo 870/1270 Revision B
Disassembly And Assembly Disassembly Procedures 103
Figure 4-41. LD Roller Assembly Installation (2)
Figure 4-42. Hook Fixing the LD Roller Assembly
Figure 4-43. Holding Compression Spring with the Hooks
CHECK
PO INT
!
When installing the edge guide to the left LD Roller
Assembly, ensure that the rib in the LD Roller Assembly
fits correctly into the groove in the edge guide. (See
Figure 4-41.)
!
Make sure that the right LD Roller Assembly is fixed with
the hook in FRAME, ASF; B. You can check its condition
from the back of the ASF Unit. (See Figure 4-42.)
!
Before assembling the ASF Unit, hold each compression
spring (1.961) with the hook of the spring bearing in the
Hopper Assembly. Then, after attaching the Hopper
Assembly to FRAME, ASF; B, release the springs from
the hooks through the cutouts in the back of the frame.
(See Figure 4-43.)
Rib in the LD Roller Assembly
Groove in the Edge Guide
Hook in the FRAME, ASF; B
Hooks
Compression
Spring 1.961